Powering on and off the Earbuds

To power on the earbuds, open the charging case. The earbuds will power on and the charging case status LED will flash to indicate the battery level of the charging case. The earbuds can also be powered on outside of the case by holding the touch sensors for 3 seconds. To power off the earbuds, return them to the charging case and close the lid. The earbuds will power off and the charging
case status LED will indicate which earbuds are charging. The earbuds can also be powered off outside of the case by holding the touch sensors for 8 seconds.

Charging

1. Power on the earbuds. The earbuds will automatically attempt to reconnect to their last Bluetooth® enabled device(s).
2. The earbuds will automatically enter pairing mode anytime they are not connected to a Bluetooth® device. To enter pairing mode while connected to a Bluetooth® device, use the device’s settings to disconnect from the earbuds.
3. On your Bluetooth® enabled device, search for and connect to HyperX Cirro Buds Pro.
4. At this point, an additional Bluetooth® enabled device that had been paired to the earbuds previously can be reconnected to allow for multipoint connectivity.